HOME IMPROVEMENT Index
Appliances
Basement
Bathrooms
Cabinets & Shelves
Faucets & Fixtures
Remodeling
Sinks & Vanities
Surround
Tiles & Grout
Toilets, Tubs & Showers

Bedrooms
Cleaning
Contractors
Doors
Driveways & Paths
Duct Tape
Electrical Systems
Family Room
Fences & Gates
Fireplace
Floor Coverings
Furniture
Handles, Knobs & Hinges
Help on the Homefront
Home Energy Efficiency
Home Office
Homeowner in Process
House Exterior
Indoor Pests
Kitchens
Lighting
Outdoor Equipment
Outdoor Structures
Painting
Plumbing
Safety
Sports-Related Additions
Staining
Stairs
Storage
Tools
Utility Room
Walls & Ceilings
Windows

BEST OF
HOME IMPROVEMENT
Flooring
Decks
Mold Quiz
Home Safety
Tiling Techniques
Lighting Solutions
Weekend Projects
DIY to the Rescue
Home Renovations
Bathroom Makeover
Kitchen Renovations
Ultimate Media Room
Be Your Own Contractor

SPONSOR LINKS

  • Plunging and Augering
  • From "Complete Fix-It"
    episode CFI-111
    advertisement

    Note: Illustration A, Illustration B, Illustration C, Illustration D,
    available using

    Clearing clogs with a plunger

    Before you plunge, seal off the rubber dishwasher drain hose that leads to the garbage disposal, if you have one, by pinching it with a C-clamp and two pieces of wood. Lift out the sink basket and clear any debris caught in the drain opening. Fill the sink with water to cover the plunger cup. On a double sink, pack rags wrapped in plastic into the drain opening (illustration A, click above to view), or have a helper hold the strainer in place.

    Set the plunger squarely over the drain and pump vigorously up and down at least a dozen times, then pull away sharply (illustration B, click above to view). Repeat if necessary.


    Unclogging the toilet

    A flange-type plunger fits into the toilet drain and exerts more pressure than the old-style cup plunger.

    1. If the bowl is full or overflowing, put on rubber gloves and use a plastic container to bail out half the water. If the bowl is empty, add water to half-full.
    2. Place the plunger over the drain opening (the larger one if there are two). Keeping the plunger below water level and firmly in place, pump up and down rapidly about eight times. If the water rushes away, you may have removed the blockage.
    3. Use the plunger again to be sure the water is draining freely. Then pour a pail of water and plunge one more time before flushing the toilet to refill the bowl.
    4. If the blockage remains after plunging, use a closet auger. You can also use a drain auger or "snake," but the closet auger is much easier.

    Using a closet auger
    1. Determine the direction in which to guide the auger. Some toilets are rear-draining (illustration B, click above to view), while others are front-draining.
    2. Feed the curved tip of the auger into the drain opening. Crank clockwise and push with moderate pressure until the auger tightens up, then crank in the other direction. When the auger tightens again, reverse the direction until the auger is as far in the drain as it will go.
    3. Pull the handle up and out to remove the auger. If it jams, push gently, then pull again. You may have to turn the handle as you pull up.
    4. Augering may either push the blockage through, or pull gunk up into the bowl. After augering, remove any large pieces, wearing rubber gloves. Finish with a plunger to ensure that the drain runs freely.

    Note: To order the new HGTV's Complete Fix-It book, see Resources, below.

    Illustrations (Copyright) Time-Life Books 2000.


    RESOURCES :

    HGTV's Complete Fix-It
    Author: HGTV

  • ALSO IN THIS EPISODE: